FREE SHIPPING OPTION FOR LOWER 48 States!!!

NSF Registered

Click Links Below For:

pdf logoSDS Vital Oxide

pdf logoIndependent GLP Lab Testing

pdf logoNashville General Hospital Study

pdf logoUniversity of Tulsa Study - Mold

pdf logoEPA Registration for MRSA

pdf logoEPA Registration for Norovirus

pdf logoNSF Registration for No Rinse No Wipe

pdf logoCarpet Sanitizer Info

pdf logoVital Oxide Label

"As the president of a microbiology testing lab, I see and evaluate new antimicrobial technologies often. After extensive testing, I can comfortably say that Vital Oxide is one of the most exciting new technologies on the market. Its dual-active system cleans well and is effective against a wide variety of pathogens - most importantly, it does the job quickly."

Benjamin D. Tanner, Ph.D.
President
Antimicrobial Test Laboratories

HMIS 0 0 0 0

mold mildew

Vital Oxide

Kills and Inhibits Mold and Mildew

BACK TO VITAL OXIDE HOME PAGE

Mold and Mildew can be found almost anywhere; they grow on virtually any substance when moisture is present, and can be a risk to our health and wellbeing, triggering asthma attacks and other allergic reactions as well as off gassing harmful VOC’s into our environment.

vital oxide 1 gallonVital Oxide has shown long-term effectiveness on mold and mold spores for up to 7 months of protection with a single treatment.

Vital Oxide can effectively be used in all areas of homes and building from the bathroom, concrete walkways and building exteriors, yet is gentle enough to be used on personal items like clothing and washing machines.

Used and recommend by mold remediation professionals, Vital Oxide has been the principle product in university and government sponsored tests showing effectiveness.

Click here for mold video from the TV series Modern Marvels.

 

vital oxide spray bottleFUNGICIDE:
To Kill Fungus on hard, non-porous surfaces: Remove as much surface dirt, mold, or mildew as
possible by cleaning. [apply] [spray] [mist] product to the surface until thoroughly wet for 10 minutes. Re-apply when cleaning or when new growth appears.

For effective control of the fungus Trichophyton mentagrophytes, the surface must be completely wet with product for 10 minutes.

MILDEWSTAT:
To Inhibit Mold or Mildew on Floors, Walls, Ceilings & Fabric:
Remove as much surface dirt, mold, or mildew as possible by cleaning. Then spray on product [from a distance of 12 inches] until visibly wet and let air dry, the surface must be completely wet with product for 10 minutes.


MOLD & MILDEW REMOVER INHIBITS MOLD & MILDEW ON HARD SURFACES & FABRIC
Inhibits and controls mold and/or mildew
Controls mold growth on hard and soft surfaces.
Inhibits growth of mold and mildew on surfaces
Kills Mold and Mildew on Hard surfaces
Inhibits [mold] [musty] odor [caused by mold and mildew]
All in one cleaner, disinfectant, mold growth inhibitor
Keeps mold [& mildew] from growing for 1 week  -or- 7 days -or- for up to -or- as long as 1 week -or- 7 days
Keeps mold [& mildew] from growing for up to -or- as long as 4 weeks -or- 3 weeks -or- 2 weeks -or-1 week-or- 7 days • Keeps mold from [reappearing] [re-growing]

REMEDIAL TREATMENT [TO [REMEDIATE] [INHIBIT] MOLD:
DIRECTIONS FOR USE:
Product can be used as part of a comprehensive mold remediation or water damage restoration program, including [this should also include]:
For use on hard, non-porous surfaces, Surfaces treated must be completely wet with product for 10 minutes
Monitoring for conditions favorable to mold growth such as [moisture ingress] [water leaks] and high relative humidity. Eliminating conditions favorable to mold growth Drying affected areas to below 20% moisture content. [Product must come in direct contact with mold to be effective.]  When water damage is suspected, first eliminate the water source. Next, remove excess water and dry surfaces thoroughly. Product can be used on materials removed for disposal. If excess water is removed within 24 hours [and surface is thoroughly dried], spraying affected surfaces, with Product will [inhibit] growth. [Structural members and/or contents] [Building materials] exposed to water in excess of 24 hours may have extensive microbial growth that is not visible. Prepare a complete assessment and remediation plan to incorporate Product use.

Recommended Mold and Mildew Remediation Websites IAQA —Indoor Air Quality Association (www.iaqa.org) EPA – Environmental Protection Agency (www.epa.gov)
New York City "Guidelines on Assessment and Remediation of Fungi in Indoor Environments" (www.nyc.gov)
IICRC - Institute of Inspection, Cleaning and Restoration Certification (www.iicrc.org)
[Standard and Reference Guide for Professional Water Damage Restoration" (IICRC S500) published by the Institute of Inspection, Cleaning and Restoration Certification (www.iicrc.org)]

(1)Remove heavy soil. [Clean surface soil from contaminated area with Product.] [For best results, [and to avoid possible interference from other chemicals,] use Product for initial cleaning.] [Use a cleaning tool (cloth, cleaning pad) suitable for the surface being cleaned.] [Remove as much dirt and mold as possible][and ensure surface is thoroughly dried.] [In some cases, staining may be irreversible.] [[Do not expect] Product [to] [will not] whiten stains [on contact].]
[2)] Refer to the Preventative Treatment section for application. [{The following steps may be inserted in place of step 2} [2)]Apply Product on area until evenly wet.
[3)] [[If desired] [If dry time][If water staining] [is a] [potential] [concern] [To promote drying] [and to avoid residue marks], [use a] [clean cloth] [or] [paper towel] [to] wipe off excess wetness.][with a clean cloth or paper towel.]
[4)] [Allow treated surfaces to dry completely.]

[Remove heavy soil prior to application] [Mold stains may remain visible following treatment] [This is normal] [In this case] [If so] [If mold stains remain] [following treatment] [reapply] [product] [and] [wipe] [or] [scrub] [area] [away stains] [In some cases, staining may be irreversible.] [[Do not expect] Product [to] [will not] whiten stains [on contact]] [If, [following treatment], additional steps are taken to [remove] [or ] [cover] [address] [treat] the stain, reapply Product as a final step [per Preventative Treatment section] to protect area from regrowth.]

Large Areas - Total Surface Area Affected Greater Than 30 Square Feet
Areas larger than 30 square feet require special procedures and individuals trained in remediation. Refer to the recommended websites for guidelines on remediation. Before using Product to mitigate large areas, you should understand one or more of these guidelines. Follow these guidelines to apply Product. [When water damage is suspected, first find the source of water and eliminate it. Next, remove excess water [and surface thoroughly dried] [and thoroughly dry surfaces]. See IICRCS500 (Recommended Websites) for guidance on water removal. If excess water is removed within 24 hours [and surface thoroughly dried], spraying affected surfaces with Product will [inhibit] [prevent] growth.]
[[Structural members and/or contents] [Building materials] exposed to water in excess of 24 hours may have extensive microbial growth that is not visible. Prepare a complete assessment and remediation plan to incorporate Product use, provide for user and occupant safety and to document and monitor the remediation process. Product can be used on materials removed for disposal and in other applications where antimicrobial use is indicated.

REAPPLICATION:
Reapply weekly or when growth or odor reappears. Determine and correct the cause of re-growth [and ensure the surface has been thoroughly dried] before reapplication. Reapply [Product] if surfaces are washed or painted.

[Reapply weekly on hard surfaces and [monthly] [every 28 days] on fabrics, or whenever [new growth] [mildew] [mold] [regrowth] appears.]

PERSONAL PROTECTION EQUIPMENT SUGGESTIONS FOR APPLICATORS
For areas less than 30 sq. feet, an N-95 respirator, gloves and goggles/eye protection are recommended to avoid mold or mold spore exposure. For areas greater than 30 sq. feet, use an N-95 respirator or half- face respirator with HEPA filter, disposable overalls, gloves and goggles/eye protection.

 

odor neutralizer foggerVital Oxide quart and gallonOur Mini Fogger has been designed to atomize and deliver Vital Oxide 2 x 1 gallon and foggerOdor Neutralizer into small areas such as rooms, kennels, stalls and small scale industrial applications. This lightweight unit has a one-quart tank with a variable spray range of 7 - 12 feet. Just plug into your extension cord and spray away the odors.

 

BACK TO VITAL OXIDE HOME PAGE

credit cards picturepaypal logo
FREE SHIPPING OPTION TO CONTINENTAL US (Lower 48)!

 
32 Oz. Spray
VitalOx-32
$18.95
Quantity:
6 x 32 Oz. Spray
VitalOx-632
$89.70
Quantity:
1 Gallon
VitalOx-1
$39.95
Quantity:
4 x 1 Gallon
VitalOx-4
$151.80
Quantity:
SPECIAL
2 x 1 Gallon
& 1 Fogger
VitalOx-2GF
$175.00
Quantity:
SPECIAL
1 Gallon & 1 Quart
VitalOx-SP
$49.95
Quantity:
 
MiniFogger
fogger
$104.95
Quantity:

CONTACT TIMES

Hard Surface Sanitization No Rinse Required: 30 sec contact time
Escherichia Coli (ATCC 11229)
Staphylococcus aureus (ATCC 6538)

To Sanitize Soft Surfaces: 5 minute contact time
S. aureus ATCC 6538
E. aerogenes ATCC 13048

Carpet Sanitization: 10 Minute contact time
Enterbacteraerogenes (ATCC 13048)
Staphylococcus aureus (ATCC 6538 )

Fungicide: 10 Minute contact time
Trichophyton rubrum ATCC MYA
Trichophyton mentagrophytes ATCC 9533

Mildewstat:10 Minute contact time
Aspergillus Niger ATCC 6275

Disinfection Bacteria 10 minute contact time
Pseudomonas Aeruginosa ATCC 15442
Acinetobacterbaumannii ATCC 19606
Staphylococcus aureus MRSA ATCC 33592
Listeria monocytogenes ATCC 15313
Legionella Pneumophila ATCC 33153
Salmonella enterica ATCC 10708
Staphylococcus aureus ATCC 6538
Klebsiellapneumoniae (NDM-1) ATCC BAA-2146
Escherichia Coli ATCC 11229
Bordetella bronchiseptica ATCC 10580
Myobacterium bovis- BCG

***Disinfection Virus 5 minute contact time
Rotavirus, Strain WA **
Hepatitis C Virus Bovine Viral Diarrhea Virus**
Hepatitis B Virus Duck Hepatitis**
Norovirus Feline Calicivirus**
Murine Norovirus (MNV-1)**
Swine Influenza (H1N1) **
Respiratory Syncytial virus, ATCC VR-26**
Human Immunodeficiency Virus (HIV Type 1) Strain HTLV-IIIb**
Influenza B Virus (Strain B/Taiwan/2/62), ATCC VR-1735**
Hepatitis A Virus ATCC VR-1541**
Hantavirus (Prospect Hill Virus) University of Ontario **
Canine Distemper Virus, Strain Snyder Hill, ATCC VR**

***Disinfection Virus 10 minute contact time
Adenovirus 1, Strain Adenoid 71, ATCC VR-1**
Canine Parvovirus, Strain Cornell-780916, ATCC VR-2016**

 

 

 


 

 

 

link to home page link to Orison links page link to products page link to contact page link to Orison search page